Sliding table carriage adjustment
The sliding table comes factory set, should the table be out of alignment due to
shipping movement see the maintenance section for adjustment procedure.
Fitting a cutter
1.
With the power disconnected from the machine:
Speed
selection knob
2.
Release the clamp screw on top of the hinged cover of the shaper fence
system and swing the cover back.
3.
Raise the shaper spindle so that it lifts the blanking disc; remove the disc
and rings.
4.
Raise the spindle to the maximum height, and ensure that the spindle is
in the 90-degree position.
5.
Open the side door and engage the shaft-locking knob; you may have to
rotate the shaft to align the locking pin with the shaft.
6.
Loosen the clamp bolt on the end of the spindle and loosen the allen set
screws. Remove the spacer rings, and clean both the spacer rings and the
spindle shaft.
7.
Select the spacers that are suitable for the cutter head that you are
fitting.
23
Summary of Contents for MT01002
Page 33: ...33...
Page 35: ...1001 02 00 00 00 Cutter 35...