laguna iFlux 10 Elite, Manual

Page: 11 / 32

10HP Bag Filter Dust Collector Manual
11
MOTOR SPECIFICATIONS
Your machine is wired for 220V, 60 HZ alternating current.
Before connecting the machine to the power source, make
sure the switch is in the “OFF” position.
GROUNDING INSTRUCTIONS
THIS MACHINE MUST BE GROUNDED WHILE IN USE
TO PROTECT THE OPERATOR FROM ELECTRIC SHOCK.
1
. This appliance must be connected to a grounded metal, permanent wiring
system; or an equipment-grounding conductor must be run with the circuit
conductors and connected to the equipment-grounding terminal or lead on
the appliance.
The installer, such as a qualified electrician, cut (or bend over) and insulate
the grounding conductor from a field wiring supply cable.
In the event of certain types of malfunctions or breakdowns, grounding
provides a path of least resistance for electric current—in order to reduce the
risk of electric shock.
Improper connection of the equipment-grounding wire can result in a risk of
electric shock. The wire with green insulation (with or without yellow stripes)
is the equipment-grounding wire. If repair or replacement of the power cord
or plug is necessary, do not connect the equipment-grounding wire to a live
(current carrying) terminal.
Check with a qualified electrician or service personnel if you do not
understand these grounding requirements, or if you are in doubt about
whether the tool is properly grounded. If you ever notice that a cord or plug
is damaged or worn, disconnect it from power, and immediately replace it
with a new one.
Full Load amperage Draw
Amp draw at 220V (prewired).................. 2 8 Amps
Amp draw at 4 4 0V ……………….................... 1 4 Amps
Power Supply Circuit Requirements
The power source circuit for your machine must be ground ed and
r a t e d f o r the amperage given below. Never replace a circuit breaker
on an existing circuit with one of higher amperage without consulting a
qualified electrician to ensure compliance with wiring codes. If you are
unsure about the wiring codes in your area or you plan to connect
your machine to a shared circuit, consult a qualified electrician.
Circuit Size (220V).................................. 50 Amps
Circuit Size (440V).................................. 30 Amps