Laguna Tools SuperMax 19-38 Combo, Owner'S Manual

Page: 7 / 41

7
Unpacking
The 19-38 Combo sander has been shipped
mostly assembled from the factory. If any
damage has occurred as a result of shipment,
notify the transportation company as soon as
possible and ask them to make an immediate
inspection. Ask for a damage or loss report. Also
notify your dealer of any loss or damage during
shipment. See enclosed Warranty Statement.
Important: To avoid problems and potential damage
to the machine, please read through the unpacking
instructions below before proceeding to set up the
machine in your shop.
1. Assemble stand or prepare dedicated bench for
sander attachment. See next section for assembly
instructions for open-stand.
2. Open “Box 1” with main sanding unit. Remove
cardboard liner. Open plastic bag.
3. Cut each corner of Box 1 to fold sides flat,
providing access to sanding unit. (Fig 2)
4. Remove two wood packing plates from bottom of
sanding unit. (Fig 3)
5. With one or two helpers, place sanding unit on
stand or bench and attach securely. Use bolts from
packing plates.
6. Install knob to height adjustment handle, finger
tighten nut to knob. Thread stud from knob
into hand wheel (Fig 2). Tighten nut against
handwheel.
7. Using handle, raise sanding head to high position
and remove packing block from under carriage
arm and motor, if so equipped. (Fig 4)
8. Remove conveyor from packaging and place on
sanding unit. The conveyor motor should be near
main motor and depth gauge.
9. Install two lock washers and two flat washers on
studs on outboard side of conveyor.
10. Install lock washer and flat washer onto two
socket head (or hex head bolts) and install into
flange of conveyor bed on inboard (motor side).
Keep support plate in place on inboard side and
make sure “fast lever” is positioned up. Fig. 4A
11. Tighten all bolts and nuts.
Fig. 3 Remove packing plates
Fig. 2 Open plastic, remove liner, cut box Fig. 4 Secure to stand, remove packing block