Laguna Tools Smartshop II Series, Manual

Page: 15 / 69

15
Machine Operation.
Manual tool release.
The tool holder can be released from the spindle
manually by pressing the green manual release
button.
Note: When the green manual release button is
pressed, the clamping method is released and the
tool will fall out. Place your hand so that the tool
holder (not the cutter) is supported.
To manually insert a tool holder, hold the tool
holder in the spindle hole while holding the green
manual release button. Once the green manual
release button is released, the tool holder will be
pulled up into the spindle hole and clamped in position.
Note: You will notice that there is air escaping from
the spindle hole. This is to blow any dust out of the
spindle hole and keep it clean.
Note: Keep the tool holders clean, lubricated with
Teflon.
Note: The spindle hole is susceptible to rust and
must be kept clean and lubricated with a Teflon
lubricant.
Note:
Depending on the option/model that you
purchased, the manual tool release button may be
located on the gantry.
Manual release button
Manual tool release
button