Laguna Tools Smartshop II Series, Manual

Page: 11 / 69

11
Assembly and setup.
Cleaning the machine.
The machine is shipped with the non-
painted surfaces protected from rust by
a film of grease. The grease must be
removed with WD40 or similar, as it
attracts sawdust and dirt. The surfaces
should then be coated with a 30W oil or
wax and any excess removed.
Fitting the dust hose.
1.
Fit the dust shroud to the two air
cylinder rods and clamp in position with
the clamping nuts.
2. Fit a 4-inch (not supplied) dust hose to
the dust shroud and secure with the
clamp. Ensure that it is tight; it is very
inconvenient to have it fall off during
production.
3. The head of the machine will move
across the complete table, and the dust
hose will follow the head. If there is
insufficient slack, the hose may break or
damage the dust shroud. It is suggested
that the hose be suspended from
the ceiling of the shop with
sufficient slack so that it will not
restrict movement. It will also be
out of the way and not causing a
trip hazard.
Electrical connections for the
machine.
There are two electrical cables.
One is the main power cable and
has no plug fitted, as it will be
dependent on your installation.
Ensure that when installing the
electrical supply to the machine
that 220v three-phase is supplied.
It is not possible to recommend a
breaker size, as this will be
dependent on the specification of
the machine that you purchase.
Air cylinder rods
Dust shroud Dust hose
Main power cable (Plug /cable not
supplied)
Water pump socket (if fitted)