Laguna Tools Robland X31, Owner'S/Assembly Manual

Page: 26 / 48

APPENDIX A
1) MAIN STOP SWITCH - red mushroom push-button switch located on the main electrical panel.
Press to stop whichever motor is running. It is wise to be prepared to stop the machine when turn-
ing it on, just in case any unknown problem arises.
Stop switches are located conveniently near all operating locations. They are the red mushroom
push-buttons of the same type as the MAIN STOP SWITCH, and each one is capable of stopping
the machine regardless of which motor is running.
Warning
Familiarize yourself with the stop nearest to the position you will be occupying as you work
your setup, so that if an emergency should arise as you are operating, you will know instinc-
tively where to reach to shut off the machine.
2) LARGE MAIN POWER SWITCH - when turned on, it allows power to main electrical panel. It has
a hole for a lock.
2a) STARTING SWITCH - A black momentary rotary switch.
ROTATE the switch bar in a clockwise direction until the motor starter solenoid is engaged and the
motor starts running.
3) TOOL SELECTION SWITCH - A black rotary switch.
ROTATE the switch bar to select the tool of your choice prior to engaging the starting switch. It is not
possible to change your selection while the machine is in operation.
4) SAW TILT CRANK - The tilt of the saw blade may be adjusted to the desired angle after the tilt
mechanism has been released by loosening the SAW TILT-LOCKING LEVER (ref. no. 6)
5) SLIDING TABLE RAIL-LOCKING LEVER - The sliding table rail may be moved either forward or
backward with respect to the saw by loosening the SLIDING TABLE RAIL-LOCKING LEVERS. Note:
there are two such levers, one at the front and one at the rear of the saw.
Both levers should be securely locked when the machine is in operation.
Note: Care should be taken to see that the sliding table rail is not accidentally disengaged from its
support while it is being adjusted for position. There are stops to prevent the rail from being disen-
gaged from its supports, since you may want to remove it from the machine on occasion.
6) SAW TILT-LOCKING LEVER - This lever is used to release the saw tilt mechanism for angular
adjustment. (ref. no. 4)
Saw
Jointer
R shaper
Mortiser
L shaper
SELECTOR SWITCH
0=NON FUNCTIONAL
24.