16
2. Setup
REVO 1216 Lathe © 2018 Laguna Tools 10/22/2018
2.
Se
tu
p
EN
It is likely that your machine will be delivered by a third party. Before un-boxing, be
sure to inspect the packaging and shipping documents supplied by the driver.
Ensure that there is no visible damage to the shipment. If any damage has occurred
because of shipment, note the damage on the bill of lading or refuse the shipment.
Immediately call the dealer store where the machine was purchased.
1. Never accept a shipment that is damaged or partial without notifying the
shipping company and the purchasing store.
Un-boxing
Once in place, carefully un-box and remove all components. Un-boxing guidelines:
1. Do not cut deep into a box with a blade as it could scratch the paint, only cut
deep enough to cut the tape or use a dull edge.
2. Organize the hardware and setup tools needed (at beginning of each set-up
section) prior to proceeding with setup.
Inventory
Key Name
Description
0
ALREVO12 EXTENSION
2.1
Extension Bed
PLAREVO1216-301
Extends the bed length of the lath or can be installed to the left side of spindle
for outboard turning ability.
2.2
Tool rest Extension
PLAREVO1216-302
Only to be used when outboard turning (left side spindle) to raise the tool rest
to the appropriate position.
2.3
Allen Head Screw
Attaches extension to end of the bed (right side extension) or the lower
outboard turning position (left side extension).
2.4
Lock Handle
Locks the Tool Rest extension (2.2) in place.
2.5
Outboard Adapter
See Image beleow, L090. The Outboard adapter
Set-Up Procedure
Tools Needed:
Allan Wrench.
1. Make sure Lathe is unplugged and cannot be powered on.
2. Remove the tail stock, banjo (tool rest) form the lathe bed by releasing the
cam locks and carefully sliding out the right side of the lathe bed.
As Bed Extension:
3. The bolt holes on the REVO 1216 bed are pre-tapped to accept the extension.
Using the three (2.3) Allen screws, fasten the extension to the right side (of the
bed) extension mounts.
4. Reverse step 2.
As Outboard Turning Bed:
5. Replace the tail-stock on the main bed for safe keeping, it will not be used for
outboard turning.
6. The bolt holes on the REVO 1216 bed are pre-tapped to accept the extension.
Using the three (2.3) Allen screws, fasten the extension to the left of spindle
extension mounts.
7. Remove handwheel or faceplate from left spindle threading.
8. Loosen outboard adapter set screws, lock spindle, and screw on the (2.5)
Outboard Adapter. Ti
9. Install the banjo on the extension by carefully sliding it into the left side of the
(just mounted) extension.
10. Install the (2.2) tool-rest extension into the neck of the banjo.
11. Install the (2.4) lock handle into the (2.2) tool-rest extension.
12. Install the tool-rest into the (2.2) tool-rest extension.
