12
2. Setup
REVO 1216 Lathe © 2018 Laguna Tools 10/22/2018
2.
Se
tu
p
EN
2.2 Inventory
Fig L007: REVO 1216 Lathe Inventory.
Key Name
Description
0
REVO 1216 Lathe
1
Center Knock-Out Rod
PLAREVO1216-1103
Used to release the headstock centers.
NOTICE:
Do not attempt to use the
knock out rod on tail-stock, release (unscrew hand wheel) the quill
completely to remove the center.
2
Face Plate
PLAREVO1216-104
3" faceplate used to fasten workpiece.
3
Face Plate Wrench
PLAREVO1836-1136
To release the Face Plate from spindle threading.
4
Drive Center
PLAREVO1836-124
Used in the headstock to turn a work piece. Does not have a bearing.
5
Live Center
PLAREVO1216-168
Used in the tail-stock to keep workpiece rotating. Has a bearing.
6
4x Rubber Foot
PLAREVO1216-199
Rubber feet to limit vibrations - Remove if using stand.
7
4x Caster Screw
PLAREVO1216-1100
8
4 x Flat Washer
PLAREVO1216-198
2.3 General Setup
The following setup sections will complete the assembly of the machine.
Installing the Leveling Casters
You may want to install the included caster on the lathe to reduce vibrations, and
protect the base from the floor. You should not install the casters if you are
plannign to use the 1216 Lathe Stand.
Tools Needed:
Alan Wrench
1. Make sure Lathe is unplugged and cannot be powered on.
2. Remove the Tail Stock and Banjo (tool rest) from the lathe by releasing the cam
lock and sliding off the end.
NOTICE:
You do not need to unbolt anything to remove
banjo or tail stock.
3. CAREFULLY tilt the lathe on its side - use a moving blanket or other soft thing to
cushion the side of the lathe in contact with floor.
4. Remove the rubber "table saver" inserts from the screw holes on the bottom of the
lathe by screwing them out.
5. Install a washer, caster, and screw on each corner.
