Laguna Tools MPSP12-4-0135, Manual

Page: 24 / 58

(21) Squaring Crosscut Fence to Blade
1. Make sure the blade is parallel with the sliding table.
2. Prepare the scrap test piece by cutting it to 32" x 32"
and number all four sides of the test piece.
3. Using the crosscut fence, cut 1/2" off of each side of
the test piece.
4. Measure the test piece diagonally from corner to
corner, at all four corners are same size.
Note
：
if both measurements are not within 1/16" then
the crosscut fence needs to be adjusted.
5. Loosen the hex nut and adjustment screw to square the
crosscut fence.
6. Tighten the hex nut and repeat 3-6.
(22) Troubleshooting
WARNING
Disconnect power to the machine when performing any troubleshooting.
Failure to do this may result is serious personal injury or death.
Saw will not start
1. Check the switch is being depressed fully.
2. Check the electrical power cord is plugged into the power outlet.
3. Check the electrical supply is on (reset)
4. With the power disconnected from the machine, check that the wiring in the plug is correct.
Check that the rubber insulation is stripped enough and is not causing a bad connection.
Check that all screws are tight.
5. With the machine power disconnected from the machine, check that the wiring to the
machine is correct. Check that the rubber insulation is tripped enough and is not causing
a bad connection. Check that all screws are tight.
6. Check that you have correct power.
7. Check that the ground wire is wired correctly.
Motor will no start
1. Emergency stop button is depressed.
2. Start capacitor is at fault.
3. Motor is at fault.
4. With the power disconnected from the machine, try to turn the blade by hand. If the
blade will no turn, check the reason for the jamming, typical reason is wood jamming the blade.
If any trouble you cannot solve it from above solutions, please call our senior engineer
or contact the agent which you ordered this machine.
25