Laguna Tools METAL PRO Series, Manual

Page: 41 / 66

41
Sanding belt breaks. Belt assembled to
machine with arrows in
the wrong direction. Replace belt.
Burn marks on the job. Sanding belt is too fine
for the job. Replace the sanding
belt with coarser grit
sanding belt.
Sanding belt clogged. Clean belt or replace
the sanding belt.
Deep sanding marks or
grooves in job. Sanding belt too
coarse. Replace sanding belt
with finer grit.
Clogged sanding belt. Clean or replace
sanding belt.
Job has rounded start
and/or finish edges. Excessive depth of cut. Reduce depth of cut.
Sanded job not
parallel. Table not parallel to
sanding head. Adjust the table to
sanding head.
Job dented or
scratched. Dirty pressure rollers. Clean pressure rollers.
Job has glazed marks
or scratches snaking
along the job. Glazed sanding belt. Clean or replace
sanding belt.
Poor sanding results. Worn sanding belt. Replace sanding belt.
Clogged sanding belt. Clean sanding belt and
check dust extraction
for blockages.
Sander will not start. No power supplied to
machine. Check that the
electrical power cord is
plugged into the power
outlet.
Check that the
electrical supply is on
(reset the breaker).
With the power
disconnected from the
machine, check that the
wiring to the plug is
correct. Check that the
rubber insulation is