Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
974355-2
17
REV032023
FILLING THE HYDRAULIC SYSTEM
Braking fluid in the cylinder, controlling the head may consume oil throughout time. Therefore, it
is important to restore the oil quantity inside the compression tank by removing the plug and
then using a syringe type injector (see picture below) to fill the tank.
Use SHELL Hydraulic OIL 32, or equivalent.
1. Put the head in the upper position in the mechanical stop.
2. Switch on the machine and push the “Line” button.
3. Remove the plug and add oil, using a syringe type injector, until it is up to the plug
opening, corresponding with the second mark on the stem.
4. Air must be bled from the tank by loosening the bleed screw, located on the side of the
cylinder, until a small amount of oil seeps out. After this tighten the bleed screw back in to
the cylinder.
5. Remove the injector and replace the plug.
TROUBLESHOOTING
SYMPTOM
CAUSE
SOLUTION
Tooth Breakage
Too fast of an advance on the
material
Decrease the level of
downward feed
Wrong cutting speed
Change the blade speed or
the diameter of the blade
