Laguna Tools 16HD Classic, Manual

Page: 28 / 100

28
5. Start rotating the wheels by hand in the normal direction. As you do
this,
watch the blade to
determine where the blade wants
to track. If the blade is tracking
too far forward or backward,
make small adjustments with the
tracking adjustment knob located
at the back of the bandsaw while
still rotating the wheel. Once the
blade is tracking in the correct
position, fully tension the blade
and re-track.
Note: The blade must be fully tensioned for final tracking.
Note: Never track the blade with the saw running.
6. Lock the tracking adjustment handle.
7. Tensioning the blade The blade
tension indicator [mounted on the
vertical post of the bandsaw]; is used
as a general guide, and the following
tensioning procedure is recommended.
Looking at the top wheel, place your
finger at the 9 o'clock position. Move
your finger down 6" and using
moderate pressure with your thumb,
press on the flat of the blade. You
should get 3/16" to ¼" of deflection.
8. Note: If you are not using the bandsaw for extended periods of time
[overnight], remove the tension on the blade. This will increase the life
of your blade and the machine. If tension is left on the machine, flat
spots or grooves can be formed in the rubber of the wheels which will
detract from the performance of the machine and in extreme cases
cause vibration when the machine is run.
9. Close the guard on the upper guide support post. Close the doors
move the door blade guard up and lock in position. Replace the table
insert, and check that the blade moves freely through the table insert.
Replace the table pin.
Check that all wrenches and loose parts are
Tracking knob
Check
deflection
here
Tension
gauge
Locking handle