- Put it slightly under tension; the sling hooks should be situated at
the boat's centre of gravity, either in the longitudinal centre or plumb
with the shroud chain-plates in the transverse plane.
Hoist gently, and control the movement of the boat with dock lines.
z
AFTER LAUNCHING
- Check the sounder and speedometer fittings for tightness if
necessary.
- Open the valves and make sure that they are watertight.
Before starting the engine, refer to the MOTORIZATION chapter.
Stepping the mast
If later you have to step the mast anywhere other than at your
LAGOON dealer, proceed as follows:
z
BEFORE STEPPING THE MAST
- Protect the mast against possible chafing by the crane hook and
cable.
- Tie down the shrouds and all the riggings to the base of the mast
with lashing long enough to guide the mast heel when stepping the
mast.
- Protect the spreader end fittings and the roller furler drum.
- Put around the mast a line of about 1.50 m with an eye and thimble
at both ends and covered with rags; place this rope over the second
level of cross trees.
- Link together both thimbles (in front of the mast) with a shackle
large enough to receive the crane hook.
- Raise the whole till it is taut under the spreader bases.
z
DURING MAST STEPPING
- Take the necessary steps to avoid damaging the mast head
equipment.
- Use the backstay and lashing at the base of the mast to control the
handling.
- Engage the electrical harness in the mast base.
- Ensure the base of the mast bears fully on its base plate.
LAUNCHING
31
LAUNCHING
3
LAGOON 44O
DANGER
Do not stay on board or under the boat during
hoisting.
RECOMMENDATION
Never place belts or fenders in contact with the
large glass windows in the hulls.
Summary of Contents for 440 S2
