Lagoon 440 S2, User Manual

Page: 41 / 122

„
Gel-coat repair
PROPORTIONS
Our products contain an accelerator. You simply need to add the
catalyst (a colorless liquid). The usual proportion is 2%.
The gel setting time (working time) is about 30 minutes, complete
hardening takes about 10 hours.
APPLICATION
- To fill a blister hole or a scratch, sand and clean the area with
acetone.
- Prepare the necessary amount of gel coat, preferably on a glass
plate.
- Apply the product with a spatula or a nib in a layer thick enough to
enable further sanding.
- In order to even out minor touch-ups on smooth surfaces, stick
cellophane tape (or better, Mylar tape) on the freshly applied gel coat.
- Remove sellotape after hardening.
- To obtain a high shine finish, sand with extra fine paper and water,
then polish.
STORAGE
Store gel coat components in a cool, dry and dark place.
The components can be kept for a maximum of 6 months.
Polyester products are flammable, so take the usual precautions.
CLEANING YOUR TOOLS
Clean your tools with acetone.
„
Steering gear
The steering system is accessed via the engine compartment.
- Regularly check tightening.
- Do not over-tighten the steering cables.
- Grease all elements.
Treat nylon, ertalon or Teflon bushings with WD40 only.
Proper settings result in gentle steering resistance, without hard
points and without looseness.
HULL & DECK
39
HULL
& DECK
4
LAGOON 44O
WARNING
Please respect the following conditions for
successful repairs:
- Dry weather.
- Temperature between 15 and 25°C.
DANGER
The catalyst is a dangerous product:
- Keep it out of the reach of children.
- Avoid any contact with skin and mucous.
- Wash with soapy water and rinse thoroughly.