376
Multiplexing
N
OTE
:
Engine speed (RPM) or road speed (MPH) limiters are options.
To tap into the TCM, Labrie uses the following wires on the Allison connector:
Table 5
Allison transmission programmed parameters
Parameters (PTO Enable)
RPM
PTO Drive Interface 1: Maximum Engine Speed for Engagement
900
PTO Drive Interface 1: Maximum Engine Speed for Operation
4000
PTO Drive Interface 1: Maximum Output Speed for Engagement
5000
PTO Drive Interface 1: Maximum Output Speed for Operation
5000
Table 6
Allison wires to be enabled
Wires
Wire # (WTEC IV)
Pack enable
117
Input
PTO
enable
143
Output
PTO
enable
130
Output neutral indicator – PTO
145
Auto-neutral pack enable (if present)
142
Table 7
Input
Wire #
Description
State
117
Pump pack enable
Active when the brakes are used, and when the PTO and
auto-neutral switches are ON (ground signal).
143
P
TO
enable
Active when the PTO switch is ON (+12V signal).
142
Auto-neutral pack input
Active when the brakes are used, and when the PTO and
auto-neutral switches are ON (ground signal).
Summary of Contents for EXPERT
