8
8)
CONTROLS
The green indicator (E) on the lower left hand side of the control panel, when illuminated indicates
that the SD-06 is connected to the electrical supply.
The on-off (I-0) switch (F) on the lower right hand side is used to turn the electrical power to the SD-
06 on & off.
All other control settings and start/stop are effected by means of the microprocessor controller (O).
Study the two diagrams, screen functions & screen details carefully. Familiarise and practise moving
from screen to screen and changing values (see next pages)
Notes.
1)
You can only change values on the screen displayed
2)
Values can be changed on the following screens :-
a)
SET TEMPERATURE.
(0-250)
next
b)
SET FAN
(0-50)
next
c)
SET PUMP
(0-50)
next
d)
SET DEBLOCKER
(Slow. Medium. Fast)
3)
The above screens will only allow values within the above range.
4)
Pressing ESC (escape) during data input will restore the original value.
5)
Start & Pump buttons only operate on the Start – Up screen.
6)
The start button is used in the set De-Blocker screen, to change the De-Blocker from Slow to
Medium or Fast.
7)
The next button is active on all screens and is used to select the next screen.
8)
The Stop button is active in ALL screens and will immediately stop the pump and jet De-
Blocker. After 20 seconds delay the fan and compressor will also stop.
9)
When the SD-06 is stopped, using the Stop button, all settings are retained.
10)
When the Start buttons on the Start Up screen is pressed the fan and compressor will start
immediately. The heat does not switch on for 10 seconds.
Remote Control and Data Logging
The SD-06 unit can be remotely controlled by means of a computer and leads via a RS232/485 link
(found on the reverse of the unit) allowing the process to be controlled and monitored (in real time)
from a PC. During a monitored run the process conditions can be printed out to give a hard copy
record. 2 versions of the software are available from Lab-Plant UK Ltd - the ‘full’ version for
unlimited use and the ‘limited’ version which allows up to 20 x 1 hour sessions. A set of leads and a
RS 232/485 converter is required, these can also be obtained from Lab-Plant UK Ltd.
