6
7)
ASSEMBLY AND PREPARATION
FITTING SD-06 TO STAND*.
If the SD-06 is to be fitted onto the optional stand it is better to do this before fitting any other items.
1. Lay the SD-06 face down on the floor with some protection to prevent damage to the front face
of the top section.
2. Remove the three screw in feet from the base of the SD-06.
3. Position the stand next to the SD-06 base and using the three screws provided screw the stand
firmly to the base of the SD-06. It is better to fit all three screws before tightening up with a
suitable Allen Key ( not provided).
4. Fit the three “screw in feet” into the stand, screw the feet fully in to give maximum stability.
5. Using two people stand the unit upright, adjust the feet if necessary to ensure vertical alignment.
* the stand is available as an optional accessory
FITTING GLASSWARE.
a) The main chamber fits into the U shaped clamp on the left hand side of the unit, slacken the
two black knobs and slide the main chamber in towards the central control panel. Lightly tighten
the two black knobs, with the 90° outlet of the main chamber passing below the control panel.
b) The cyclone fits directly into the exhaust stack to the right of the control panel. Loosen the
knurled cap on the end of the exhaust stack. Enter the top of the cyclone into the cap, push the
cyclone upwards. There will be some resistance as the glass tube slides up through a rubber
seal.
Rotate the cyclone 90° to pass the inlet flange over the black nylon support arm. Move the
cyclone down allowing the inlet flange to rest on the support arm.
c) The white PTFE transition tube fits between the outlet flange of the main chamber and the inlet
flange of the cyclone. Using the two clamps fasten the main chamber, transition tube and
cyclone together, tighten clamps finger tight only.
d) Finally position glassware and tighten knurled ring on the exhaust stack and the two black knobs
holding the main chamber.
