SLx 40
SETUP (continued)
Figure -9 Install Microscope
Power
Cord
Dust
Cover
Focusing
Rod
Chin Paper
Wrenches
Guide Rails
Replacement
Bulb
Figure -10 Accessories
Figure-11 Power Supply Assembly
Slide
Microscope
Assembly
Lock
Turn Counter Clockwise
11
8126400-795
SLx 40
Issue 1.3
Printed on April,2019
UNPACKING AND INSTALLATION
13. Install the Microscope Assembly onto the top of the arm
by sliding it into position, making sure it is up against the
stop. Then, tighten the lock Knob located on the right side
of the Microscope Assembly. Refer to figure-9.
NOTE:
Do not adjust the Microscope stop knob behind the
base of the microscope, or the vertex distance will cause
misalignment of focus and require re-calibration of the
slit lamp assembly.
14. Remove the accessories and store them in an
Appropriate place so that when they are needed they will
be available. Refer to figure-10.
APPLICATION OF INPUT POWER
WARNING:
CARE MUST BE TAKEN TO ARRANGE THE CABLES
FOR THE ACCESSORIES SUCH THAT THEY DO NOT PRESENT
A TRIPPING HAZARD TO THE EXAMINER OR A DANGER TO
THE PATIENT.
WARNING:
POSITION THIS INSTRUMENT SO THAT IT IS NOT
DIFFICULT TO OPERATE THE DISCONNECTION DEVICE (PLUG).
1. After the unit is in its secure location, apply the correct
input voltage to the instrument using the Power Cord from
the Accessory Tray.
NOTE:
The powet inlet is located on the backside of the
Power Supply Assembly.
2. Press down on the “I” located on the ON/OFF Switch.
Refer to figure-11.
NOTE:
The ON/OFF Switch will illuminate green when
there is power to the unit. When the ON/OFF Switch
is set to off, the green light will turn off.
DISCONNECTION OF INPUT POWER
1. At any time, the power switch can be set to OFF. The unit
does not have a power down sequence. To terminate
operation of this instrument, press the ON/OFF switch to
the OFF position (O).
2. If this instrument is intended to be OFF for an extended
period of time, it can be disconnected from power by
detaching the power cord from the receptacle.
