10
Chin Rest
Wire
Base Lamp
Wire
Figure- 8 Connections
Figure- 5 Microscope, Base, Power Supply &
Accessories
Figure- 6 Install Base
Slit lamp Base
Accessories
Power
Supply
microscope
Slide
C
Figure. 7 Assembling Power Supply on the
Power Supply Bracket
Move
Handles
up or
down
Allen Cap
Screw
Figure- 9 Adjusting Patient
Handle Height
D
Figure- 7 a. Earthing wire attaching
screw
SLx 40
SETUP (continued)
8126400-795
SLx 40
Issue 1.3
Printed on April,2019
UNPACKING AND INSTALLATION (continued)
7. Open the box marked as “Microscope Assembly”.
Remove the microscope Assembly, Slit Lamp
Assembly, Power supply and Accessories. Refer
to Figure-5.
8. Install the Slit Lamp Assembly onto the tracks of
the Table Top and slide the Guide Rail Covers around
the tracks. Refer to Figure-6.
9. Assemble Power Supply to the table top just by
pushing into the hole shown as (C), refer figure-7.
10. Connect the power supply earthing wire with
table top at point “D” using 3mm Allen Wrench. Refer
fig-7a.
11. Attach the Base Lamp Wire Connector to the back
of the Power Supply Assembly. Refer to fig-8.
12. Connect the Chin rest target light Connector to
the Power Supply Assembly by plugging it in.
Refer to Figure-8.
13. Using the 4mm Hex Wrench, adjust the Patient
Handles by loosening the Allen Cap Screws that are
Securing them to the Chinrest Posts. Slide the
Patient Handles up or down to the desired height,
and secure them in place by tightening the Allen
Cap Screws. Refer to Fig.-9.
