LM3510 Print & Apply Label Applicator
USER'S MANUAL
Page 30
Made in the U.S.A.
© 2019 LABELMILL
11/01/2019 Model LM3510
•
TAKE UP
This is used to delay the start and stop of the take up motor.
PROGRAMMABLE BLOCKS:
Start delay – delays (x) seconds after start print before starting take up motor.
Stop delay – take up runs (x) seconds after end print signal is received from printer.
Jog take up – press the UP ARROW to start and the DOWN ARROW to stop the take up motor.
•
COUNTER
Used to reset the internal counter of the control.
•
PRINT TYPE
The print type command is used to activate the print repeat cycle in the supplied print engine. This feature will
continue to print the
last label
in the buffer after the buffer count has expired.
PROGRAMMABLE BLOCKS:
Reprint – Turns reprint option ON or OFF
Serial End – On or Off / sends a serial command out comm. #1 serial port(ESC / D / CR) at the “End of Cycle”.
Char-1
ESC
27 decimal
Char-2
D
68 decimal
Char-3
CR
13 decimal
Print Fault Timer – Programmable timer for fault to output if end of print signal is not received in specified time
after receiving the trigger signal.
•
ENCODER
Provides a more consistent way to apply labels to a product. With this option a distance from the trigger point can
be set at which the label is to be applied. Note: optional encoder must be used with this feature.
PROGRAMMABLE BLOCKS:
Encoder - used to turn the encoder option on or off.
Enc Override – Allows fine-tuning of the ratio of applicator speed to conveyor speed.
Trigger Distance - used to apply the label a certain distance away from the trigger point.
Start Comp Dist – Start Compensation Distance used to compensate for variable speed applications.
Max Convyer IPM – Enter Maximum conveyor speed in inches per minute.
Enc lines/inch - tells how many pulses the encoder will count with 1 inch of travel. (25 to 500 counts per inch)
3-03
