11
Fix No. 2 support links of the cover (4) to the transom by using No. 2 screws M6x10 for each link and connect the
articulation by inserting the plastic pin.
In case of automated equipment longer than 4500mm. provide No. 3 support links, one of which must be exactly in
the centre of the transom.
The central link can be useful, in case of double leaf door, to support the motion radar connecting cable.
Should the third link be required to support the radar connecting cable, regardless of the transom length, it is
possible to order it separately.
Then, turn the articulation upwards towards the link, in
order to close it.
Install the driving belt (11) rolling it up around the idle
pulley; the belt tensioning screw of the pulley shall be
loosened.
Insert the driving belt in the bracket of the lower belt
coupling taking care to make it adhere thoroughly to
the eyelets provided in the bracket and lock it by
tightening the screw slightly.
Pull manually the belt from the upper side of the
pulley towards the inside of the transom and insert
it in the upper belt coupling bracket (only for double
leaf doors).
Take care to place the carriages with belt coupling
next to the closing mechanical limit switch or next to
the electric lock bracket, if any, before tightening
the belt block screws.
23
24
25
26
27
28
23
24
23
25
26
27
28
Summary of Contents for EVOLUS
Page 2: ......
