19
english
To interrupt dispensing in continuous mode, stop the dosage by pressing the same key K5GRx . This de-
energises the solenoid valve and the pump, and the signal lED is consequently turned off.
Dispensing in continuous mode stops automatically (if it is not stopped) when the maximum product quantity
is achieved; this quantity can be controlled both in volumetric mode on achievement of 6000 pulses, as well
as by means of a dispensing Time-out (see paragraph entitled AlARMS).
IMPORTANT: THE “CONTINUOUS” CyClE STARTS WHEN THE K5GRX KEy IS RElEASED (WITHIN 5
SECONDS OTHERWISE THE PROGRAMMING PHASE bEGINS) AND NOT WHEN IT IS PRESSED. IN-
STEAD, DOSAGE STOPS WHEN THE KEy IS PRESSED.
TEA CyClE
DISPENSING
When the key relating to the Tea dose is pressed
(K6gRx),
the Tea solenoid valve is activated
(eVTeA)
and
hot water is dispensed. This operation is indicated by the lED
(l6gRx)
corresponding to the key pressed
lighting up.
When the cycle starts, a Timer is activated which, once the time value set during the programming phase is
achieved, interrupts product dispensing.
The dosage function permits the contemporary dispensing of Tea and coffee cycles.
K6GRx
The display shows
Tea
stop dispensing tea while in progress
It is possible to interrupt dispensing while in progress before the programmed amount of time has passed.
Simply press the same key used to start dispensing the tea dose.
This de-energises with immediate effect the solenoid valve
eVTeA
and
interrupts product dispensing and
returning the dosage to idle-on status.
The control unit is designed to manage three different tea doses
(one per unit).
TEA + PUMP
Tea dispensing can be combined with the pump.
See TECHNICAl lEVEl Programming.
AUTOSTEAM SPOUT DISPENSING CyClE
This function and the keyboard dedicated to perform it is activated in TECHNICAl lEVEl Programming (see
relevant paragraph)
