(P/N)762.128 Rev B EN 05/10 • © copyright 2009-2010
Kaba Mas LLC
page 7
The 3710 Entry Device comes with the mylar portion of the keypad unattached.
1. Feed the key pad cable through the spindle cable hole from the front of the safe door. (Figure 5).
2. Position the Entry Device over the screw holes on the door, and lift the keypad to expose the
mounting holes.
3. Install the two #8-32 screws (US) or the M4-0.7 screws (metric) to mount the Entry Device to
the door.
NOTE:
Ensure that the battery connector is routed through the battery open at the bottom of the
housing, and no wires are pinched under the housing.
4. Remove the adhesive strip from the back of the keypad and carefully align before adhering to
the housing (Figure 6). Prior to adhering, make sure that the housing is completely free of debris
such as filings, dust, etc., for the best possible contact.
WARNING:
Once installed, the Entry Device cannot be removed from the safe door without causing
physical damage to the keypad.
5. Ensure that the Entry Device cable is running through the channel at the back of the lock. Refer to lock
installation instructions which are available at www.kaba-mas.com.
ALTERNATE INSTALLATION
The option adapter plate (p/n 3716) may be used to mount the 3710 Entry Device to a safe with
vertical mounting hole (12 and 6 o’clock).
1. Mount the adapter plate centered on the through hole. Attach the dial
plate with the two mounting screws US 8-32 (US) or the M4-0.7 (metric).
Then follow the above installation instructions.
BATTERY INSTALLATION
1. If installed, remove black plastic battery compartment cover (located at the bottom of the keypad) by
gently pulling downward on its handle.
2. Allow the battery connector and its attached leads to drop down and out of the battery
compartment. If it does not drop, gently pull on the battery connector until it does.
CAUTION!
Hold onto battery terminal connector to avoid pulling the wires out of housing.
3. Connect a new 9-Volt alkaline battery to the battery connector.
4. Push the battery and the leads completely into the battery compartment.
5. Install the battery cover by placing one side of the cover in position and then pressing the
other side into position with your finger.
3716
Figure 5
Figure 6
3710
3710 ANGULAR ENTRY DEVICE (ADDITIONAL INSTRUCTIONS 3716 ADAPTER)
