22
2012/3/2Ver1.1+V1.0
z
User Mode
1.
This mode will record the last state user entered. Press
key to select this
mode and press
key to enter. You can press MODE key again to adjust the
resistance from 1 to 32 level (press
to adjust from L1-L20) .The
corresponding light will flash during setting this level, then press
to
confirm and into next level setting. After finish setting 32 levels, press
key to
set time.
2.
Setting time
:
(default value: 10 minutes
;
range: 0
,
10-60MIN). Time of each level
is the editing time divided 32 levels.
3.
After setting
the target time value
or while setting parameters, press
or
key to execute the program(The unset resistance will adopt the default value:
LEVEL1 or the last LEVEL). Time is executed by countdown.
4.
If you want to change the parameters, press
key to back to the first item to
reset or press
key to directly back to the start/ready status.
5.
User can press
key to choose the desired LEVEL(According to the rotate
speed, the same LEVEL has different resistance feedback)
z
Race Mode
1. Press
key to select this mode and press
key into the target value setting:
It will ask user to set target distance(0.1
、
0.4
、
1.0
、
2.0
、
5.0
、
10.0 kilometers/miles)
and challenge time of target distance. Press
to adjust. At the time,
program will compute Pacer speed according to the editing value.
Computer Speed(Pacer Speed)=Target Distance/Target Time. Unit is
KM/HR(ML/HR)
2.
Make sure the pacer speed is correct. Press
to start race. After showing3,2,1
on screen, user starts race with computer.
3.
If the input value is invalid, user should adjust it
again
, otherwise, this mode can’t
be started.
4.
Blue point represents user and red point represents computer in the playground. In
the bottom right corner of playground, it will show the distance that the computer is
ahead or behind user. User should reduce the his own resistance to catch up with or
overrun
the computer
(red bike image )
.
5.
When one of the players reaches the target distance,
the program is over
and the
Summary of Contents for DK850BAF01AA
