3
If the solar transmitter is placed into a dark environment for 72 hours, will goes into Stop
mode.
If the user cover the solar cell for 10 seconds and press the reset button, "StP" will be
displayed on the LCD. Then the transmitter enters STOP mode.
Idle Operation Mode:
This mode occurs when the battery voltage drops lower than 2.4V.
LCD is turned off.
Does not perform temperature measurement and transmission.
The environment brightness is checked every 5 seconds.
If battery voltage is raised higher than 2.5V, the unit will go into Normal mode.
If the solar transmitter is placed into a dark environment for 72 hours, the will go into Stop
mode.
Stop Operation Mode:
This mode occurs when the solar transmitter is placed into a dark environment for 72 hours
or the user covers the solar cell for 10 seconds and presses the RESET button.
The transmitter is in a standby state. The does not perform any operations and the LCD is
off.
Under a bright condition, press the reset button to wake up the transmitter into normal
operation mode (battery voltage is higher than 2.5V).
This is the most power saving mode.
TO INSTALL / REPLACE BATTERY IN THE SOLAR STATION
The Solar Station can use either the included 2 x alkaline rechargeable batteries (charged by
solar panel; included) or 2 x AA alkaline battery (non-rechargeable; not included).
INITIAL SETUP
It is very important to
follow these steps
:
1.
First, remove the label covering over the battery compartment on the back.
