L3Harris HP-01, User Manual

Page: 12 / 66

1-4 General Information
1.5 HP-01 Main
specifications When not differently specified the following specifications are referred to an
operating ambient temperature of 23°C and relative humidity 50%.
Table 1-1 Technical specifications of the HP-01 Magnetometer - Field Analyzer
Frequency range DC ÷ 1000 Hz
Measurement range
(1)
10 µT ÷ 60 mT
(lower range)
10 mT ÷ 10 T
(higher range)
10 µT ÷ 10 T
(advanced autoranging feature)
Overload 20 T
Dynamic range
(after zeroing)
120 dB
Resolution
(2)
100 nT
(lower range)
100 µT
(higher range)
Displayed average noise level
(3)
10 µT
Frequency flatness
(typ)
0.5 dB
(DC ÷ 1000 Hz)
Expanded Measurement Uncertainty
(4)
1%
Field sensor Triaxial orthogonal Hall effect devices
(temperature compensated)
Sensor area approx.: 0.6 x 0.6 mm
(higher range)
0.15 x 0.15 mm
(lower range)
Acquisition method
Simultaneous triaxial acquisition
Spectrum analysis method Realtime Gapless
(5)
FFT
SPAN 20 Hz 30 Hz 100 Hz 1000 Hz
Frequency resolution 0.2 Hz 0.3 Hz 1 Hz 3 Hz
RBW
(-3 dB)
0.8 Hz 1.2 Hz 4 Hz 10 Hz
Reading update time
< 350 ms
Start frequency User selectable within the whole range
Stop frequency
User selectable within the whole range
Time domain analysis method DC to 1 Hz FIR filter 1 Hz (-3dB), reading updating time 67 ms
Calibration
(6)
internal E 2 PROM
Temperature and humidity meter -20 to +55 °C 0.01° resolution 5 to 95 % 0.1% resolution
Typical temperature deviation
@ 0 Hz referred to 23°C 0.05% / °C
Dimensions
Sensor stick
φ
9 mm, L 143 mm
Main body
φ
43 mm, L 55 mm
Overall length 200 mm
Weight
100 g
Tripod support Threaded insert ¼”
Internal battery 3.7 V / 250 mAh Li-Ion, rechargeable
Operating time
> 6 hours
Recharging time < 2.5 hours
External supply 10 ÷ 15 VDC, I = approx. 100 mA
Optical fiber connection
Serial Optical Interface 115200 Baud
(7)
- RP02 connector
up to 40 m (USB-OC)
Firmware updating Through the optical link by USB or RS232
Self test Automatic at power on
Operating temperature -20 to +55 °C
Operating relative humidity
(8)
5 to 95 %
Charging temperature 0 to +40°C
Storage temperature
-30 to +75°C
(1) For each single axis. Positive and negative at DC.
(2) At 20 Hz and 30 Hz SPAN.
(3) After zeroing. DANL is frequency and SPAN depending. The specified performance is referred to 0 Hz and SPAN 20 Hz.
(4) At DC.
(5) Overlapping for SPAN lower than 1000 Hz
(6) Recommended re-calibration interval 24 months
(7) 38400 Baud with 8053B
(8) Without condensation
Specifications are subject to change without notice