Rigging procedures
Array removal
About this task
All along the procedure:
Strictly follow the sequence of the successive steps.
Systematically verify that each BLP is fully inserted.
For clarity purposes the loudspeaker cable removal procedure will not be described.
The loudspeaker cables will not be represented on the gures.
Procedure
1.
If the array to disassemble is an SB18 standalone array, directly go to step
(p.87).
If the array to disassemble is an SB18/Kara mixed array, begin the procedure by applying the Kara standalone array
(p.66) to 12, and then continue from step
(p.86) below.
2.
Lower ARRAY#1 into the tray. The bottom SB18 must be resting on both KARA-MINIBUEX.
3.
Remove ARRAY#1 from the SB18 array as follows:
a) Remove the four T-BLP from the
link
holes of both KARA-MINIBUEX.
b) Raise the SB18 array until it is separated from ARRAY#1.
c) Re-insert the four T-BLP into the KARA-MINIBUEX
storage
holes.
4.
Remove ARRAY#1 from under the SB18 array.
86
Kara owner's manual (EN) version 1.0
