Rigging procedures
6.
Attach a dolly board to SB18#2 and remove SB18#2 from the rigging location.
7.
(p.120) and
(p.121) until all SB18 are separated from the array.
8.
Remove both M-BAR/M-JACK assemblies from the M-BUMP as follows (repeat for each one):
a) Remove both T-BLP from the M-BAR studs.
b) Lift up the corresponding side of the M-BUMP and remove the M-BAR.
c) Re-insert both T-BLP into their storage holes.
9.
Remove both M-JACK from each M-BAR as follows (repeat for each M-BAR):
a) Remove the safety pin (see
Safety pin removal and insertion
(p.199)) and bolt from the M-JACK.
b) Secure the preceding bolt and safety pin to a shackle.
c) Remove the M-JACK from the M-BAR.
b.
a.
Kara owner's manual (EN) version 1.0
121
