Rigging procedures
5.
Remove the KARA-MINIBU/KARA-MINIBUEX from KARA#1 as follows:
a) Remove the four R-BLP from the KARA-MINIBU.
b) Remove the KARA-MINIBU/KARA-MINIBUEX from ARRAY#1.
c) Re-insert the four R-BLP into the same KARA-MINIBU holes.
6.
Close the four KARA#1 arms as follows (repeat on both sides of the enclosure):
a) Remove the front top R-BLP from its
link
hole, slide the front arm up, rotate it down, and lock it in place by re-
inserting the R-BLP into its
storage
hole.
b) Remove the rear top R-BLP from its angle hole, slide the angle arm so as to align the cursor with the storage label,
and lock it in place by re-inserting the R-BLP into its
storage
hole.
7.
Attach the lid to the ight-case.
The procedure is continued with an array composed of four SB18 enclosures to cover all possible cases.
8.
If not already done, detach both safety slings from the KARA-MINIBU.
9.
Lower the array until the bottom SB18 (SB18#4 for example) rests on the ground and the SB18 above (SB18#3 for
example) rests onto it.
Kara owner's manual (EN) version 1.0
87
