9
Step 1: CLEANSE
1.
Install the metal treatment head. Remove the protective plastic cover from the Ion head before
use.
2.
Remove excess make-up and eye make-up.
3.
Apply a water based cleanser to the treatment head or to your face as you prefer and
dampen face with water
4.
Turn on device by pressing and holding the On/Off power button for 2 seconds until a long
beep sounds.
5.
Press the +/- treatment button once so that the CLEANSE light is on.
6.
Select level. We recommend you start at high by pressing the level button 3 times until HIGH
light is turned on. If the current feels too strong reduce down from this level by pressing the
level button.
7.
Cleanse with Pro-lift+ as you would with your fingers working in gentle rotating and/or lifting
movements over entire face avoid lingering around the eye area. Ensure your finger is in contact
with the conductive panel at all times.
8.
After 4 minutes there will be a short short beep and PRO-LIFT+ will go in to standby mode,
ready for the next stage.
9.
Rinse off any excess cleanser with water. Do not dry face and proceed to Step 2.
