14
Step 5: Red LED Light Treatment
1.
Install Red LED light treatment head.
2.
If you have not already completed steps 1, 2 and/or 3 remove makeup and cleanse your face,
then towel dry.
3.
To turn on Pro-Lift+, press and hold On/Off power button for 2 seconds until a long beep
sounds. Press the Photofacial button.
4.
Hold the treatment head in contact with the area of the face to be treated for 3 minutes. Red
light will be visible on contact with the skin. For effective treatment the treatment head must
be held in constant contact for 3 minutes, do not move treatment head when using LED lights.
5.
After 3 minutes a short beep will sound to signal to move to the next position to treat. You can
treat just the areas that suffer from deep wrinkles, hyper-pigmentation and/or ageing, or for a
complete facial treatment follow the 6 positions shown in the diagram on page 15, holding the
treatment head in contact with each area for 3 minutes each time.
Please Note for Photofacial treatments:
- The LED lights do have a natural pulse, this is normal.
- Blue and Red LED light treatment heads are installed with contact sensors and will only illuminate
when in contact with the skin.
- The POWER LEVEL Button is disabled when using LED light treatment heads
- If not used for 3 minutes the PRO-LIFT+ wil return to standby mode and will automatically turn
off after a further 4 minutes.
- During Photofacial Treatments, contact with the Conductive Panel is NOT necessary.
- If contact is lost with skin during the 3 minutes the timer will reset and the short beep will not
sound until a full ongoing treatment of 3 minutes is completed.
