12
Aluminum material is a smooth mill-finish requiring little care. Wash-
ing with soap and water plus rinsing should suffice. There is no hard
substrate material underneath and aluminum will show slight waves
due to sun and heat causing expansion of the aluminum material.
Second, a full roof of fiberglass is used on one model with out any
roof seams. Roof begins at front bottom, goes all the way across
roof and ends at rear bottom. Moldings will screw on top of material
just like front and backs.
Third, A soft fabric is glued onto a substrate OSB board, which is
attached roof frame work. Three types of material have been
used:EPDM full rubber cover, TPO (Thermo Plastic Olefins) and
SUPER FLEX system,
The proper care, cleaning and maintenance of your SUPER
FLEX AND TPO roofing is quite simple because of the basic proper-
ties and longevity of the material itself.
Periodic cleaning is the primary maintenance. Alpha Systems
suggests using Murphy’s Oil Soap, Top Job, or Spic and Span with
a soft nylon brush or sponge. DO NOT USE solid or granulated
cleaners, as they will mar the natural finish.
DO NOT USE Armor-All or other oil/solvent base cleaners as
they will leave a slick surface.
A good thorough cleaning with some elbow grease and the sug-
gestions above should keep your roof looking good and remove
most stains. For more stubborn stains, you should contact your au-
thorized dealer.
If you keep your soft fabric roof clean, you will be performing the
primary maintenance necessary to keep it looking good and extend
its longevity.
Annual inspection of the roof is suggested. Check the mem-
brane for possible damage and check the caulk/lap sealant used in
all termination vent areas, around roof vents and any other attach-
ments. Be sure sealant is fully attached to roof membrane and not
coming loose.
Royal Tuff-Ply and Super Flex are UV resistant. It will not re-
tain odors or rot.
There are one or two seams on top of the roof, front and rear,
attaching the front and/or rear panel to the roof material. A putty
tape seals the seam, which is covered with a flat extrusion plus roof
sealant, to be inspected and resealed as required. This needs to be
done twice per year, spring and fall.
Sealant to use is Alpha Systems 1010 over seams which is re-
quired for full sealing seams.
PDF created with pdfFactory trial version
