Kyungnam Machine Company KN-1248-G3, Manual, Page: 96 / 123

5. CUTTING TABLE ADJUSTMENT
- CUTTING TABLE GAP SHOULD BE
1~1.5mm BIGGER
THAN WIRE DIAMETER TO BE CUT.
E
A B C
- FOR SETTING TABLE GAP, LOOSE BOLTS OF A AND C FIRST, AND LOOSE BOLT B AND
ADJUST GAP BY TURNING NUT(E) TABLE GAP WIDER !.5mm THAN WIRE DIAMETER
TO BE CUT AND TIGHTEN BOLTS AGAIN.
- 4~5 PIECES OR WIRES CUT AND HOLD INSIDE OF TABLE BY BEARINGS.
AND PUSH DOWN ONE BY ONE PIECE. IF FEW WIRES DOWN, GIVE MORE
BEARING TENSION BY NUT D.
- IN ORDER TO PUSH DOWN A WIRE SMOOTHLY, LESS BEARING TENSION FRONT 3
NUTS D AND OTHERS SHOULD BE MORE TENSIONING THAN FRONT 3 NUT.