Make B-Pipe
1. Input Total Length.
- Touch green bar to Pop-Up key pad to put in digit.
- Input length should be -50mm from the actual longitudinal wire (Copper Ring+Welding Gap)
※ Max. length is 2,600mm.
- If you put in digit more than 2,600mm, it show 2600 as Max.
※ All input digit should be metric mm for arithmetic operation(Inch is not accepted)
2. Input Stat Ring and Last Ring.
- Touch green bar and input digit 0~12
- Start Ring makes first spigot spiral wire pitch because Transfer is not moving before
welding points set up digit.
- Last Ring makes last bell bottom spiral wire pitch because Transfer is stopped but
welds more points set up digit and stop Drum rotating.
- Narrow pitch for less Ring count and wider pitch for many Ring count.
3. Input Start Slow Length.
4. Input Bell Length.
5. Input Leg Length.
- After input Start Slow Length/Bell Length/Leg Length, Barrel Length is input automatically.
5. Input Slow Pitch.
- Min. input is 30. Lower than 30 is not accepted.
- If input is lower than 40, Drum is turning faster than barrel
- During slow pitch length, Transfer slows peed is fixed with 1000 or 1500, Drum are rotaring
as per pitch.
Summary of Contents for KN-1248-G3
