KLS12 manual
www.kystar.com.cn
7
VI、Wiring and installation
Wiring diagram
Installation step
1
、
Wiring as shown in the picture, connect the DVI port of the graphics card to the DVI-IN
input port of the 2-in-1 controller;
2
、
Then connect the wires as shown in the figure, connect the computer to the USB-CFG
control port of the device through the USB control cable, and connect the output network port of
the two-in-one controller to the receiving card;
3
、
After making sure that the wiring is correct, power on and open the gold card debugging
software. The software can correctly identify the model of the sending card and the number of
receiving cards, and the debugging can be done normally.
Signal source
LED screen
Power cable
Lan cable
USB control cable
Monitor
