Kyocera TJEP ULTRA GRIP 25, Manual

Page: 6 / 76

6
Applications
Tying of re-bars used for: prefab. concrete elements,
on-site concrete constructions, floors and walls.
Tying of floor heating pipes.
Safety features
To increase safety when tying, the re-bar binder is
equipped with safety features.
WARNING! Before use, make sure that the
device works as intended. Otherwise, do not
use the re-bar binder.
Trigger lock
The re-bar binder is equipped with a trigger lock.
Lock the trigger and remove the battery when the
re-bar binder is not in use.
!
Trigger
Trigger lock
Machine specification
Technical info. ULTRA GRIP 25 ULTRA GRIP 40 ULTRA GRIP 58
TJEP no. 124012 124002 124022
Weight 2.5 kg 2.6 kg 2.8 kg
Size (L × B × H) 281 × 109 × 300 mm 297 × 109 × 300 mm 312 × 109 × 310 mm
Wraps per tie 2 or 3 2 or 3 2 or 3
Workpiece thickness 8 - 25 mm 12 - 40 mm 30 - 58 mm
Ties per charge +5.000 (3 wraps ) +4.500 (3 wraps ) +4.000 (3 wraps )
Battery 18V 4,0Ah Li-ion
Charger
Use only approved battery charger Li18C
(TJEP no. 124201).
Charging time Full charge = 90 min.
Wire specification
Model
Box: 20 coils (TJEP no. 124152)
Box: 40 coils (TJEP no. 124153)
Diameter 0.8 mm
Length approx. 100 m
Material Galv.
Ties per coil ULTRA GRIP 25 ULTRA GRIP 40 ULTRA GRIP 58
2 wraps approx. 220 approx. 160 approx. 120
3 wraps approx. 160 approx. 120 approx. 90
When you start tying, release the trigger lock by
pushing the lock left and upwards.
Curl guide
If you pull the trigger while the curl guide is open, the
re-bar binder will make a warning sound and refuse
to tie. To start tying, release the trigger and make
sure that the curl guide is closed.
Battery
Durability of the battery
If the battery is fully charged, but the operating time
is significantly reduced, the battery is defective and
must be replaced. If the battery temperature is low
(10°C or lower) the charging time will be prolonged.
WARNING! Do not use defective batteries.
The re-bar binder will not work properly.
!
Curl guide