Kyocera TJEP ULTRA GRIP 25, Manual

Page: 10 / 76

10
10. Adjusting the wraps
By default the machine is set for 3 wraps. Changing
the setting to 2 wraps: Turn off the machine on the
main switch. Press and hold the trigger while turning
on the main switch. The machine is now set for 2
wraps per tie. If the machine is turned off, it will auto-
matically be set for 3 wraps again.
11. Battery-saving function.
The machine will automatically shut down after 10
min stand-by without being used.
How to replace the wire coil.
WARNING! Set the main switch to OFF po -
sition, activate the trigger lock and remove
the battery.
1. Push the release lever until it is caught by the
release stopper.
2. Remove the wire coil.
3. Push the reel stopper to release the reel stay and
open it at the same time, and remove the wire coil.
4. Load new wire coil (refer to the instructions for
loading wire coil on page 9) .
5. The torque dial adjusts the tension of the ties.
We recommend:
• 2 wraps = position 1 - 6
• 3 wraps = position 6 - 10
6. Perform a test tie, to check if the torque dial is set
correctly.
Correct use
1. Place the arm A unit in a 45° angle over the re-bar
cross surface and push the mouth towards the re-bar .
2. Place Arm A perpendicularly on top of the re-bar
cross surface and with the mouth centred over the
cross.
WARNING! Do not move the re-bar binder
while it is tying.
3. The ties should be made in alternating directions.
Release stopper
Release lever
Wire
Pipe
Reel stay
Reel stopper
45°
!
!