Kyocera TJEP RE-BAR 40, User Manual

Page: 61 / 92

61
English
2.13. When inserting the battery, check the
following points. Do not load a wire coil in the
RE-BAR tier if:
There is a sound from the curl guide, even though
the RE-BAR tier is not in use.
The RE-BAR tier is warmer than usual, smells odd,
or a noise is coming from the machine when not
in use.
The RE-BAR tier starts itself without being
activated.
Do not use the RE-BAR tier without correcting the
fault.
If it is not possible to correct it, contact your dealer.
2.14. Do not make any modifications to the RE-
BAR tier.
Modifying the RE-BAR tier does not only reduce the
function of it, but also the level of security. Do not
make any modifications to the RE-BAR tier.
2.15. Make sure that the RE-BAR tier is in good
condition.
To maintain the functionality and the quality from the
work of the RE-BAR tier, maintain it properly and
make sure that it is being serviced on a regular basis.
Remember to keep the handle free of oil and dirt.
2.16. Use only approved batteries.
Use only the approved type of battery LI-300 for
this RE-BAR tier. If using another power source, for
example another type of battery, dry cell battery or a
car battery, the machine can break down or burst into
flames.
2.17. Charge the batteries before use.
A new battery or a battery which has not been used
for a long period of time, may be discharged and has
to be fully recharged before use.
2.18. Precautions in connection with battery
charging, chargers and batteries.
2.18.1. Use only approved charger.
Use only the approved charger which comes with
the RE-BAR tier and batteries.
The batteries cannot be recharged with other
chargers – this may cause damage, overheating
or fire.
2.18.2. Recharge the batteries with the correct
voltage.
Make sure that the charger is connected to an
ordinary 100-240V outtake. Using another voltage
than 100-240V will cause a malfunction and/or
overheating, causing damage to the battery and
charger.
2.18.3. Never use a booster-type transformer.
2.18.4. Never charge the battery in a wet or
damp environment.
Charging in these conditions may cause an electric
shock or short circuit.
2.18.5. Do not touch the plug or charger with a
wet hand or glove.
You will risk injury from electric shock.
2.18.6. Do not place anything on the charger
during use.
The charger may become overheated and
eventually catch fire.
2.18.7. Make sure not to place charger and
battery next to a heating source or open fire.
2.18.8. Do not place the battery near flammable
items.
2.18.9. Charge the battery in a well ventilated
place.
Avoid placing it in direct sunlight.
2. Safety instructions