Kyocera BDX-2, Owner'S Operating Manual

Page: 9 / 12

8
SPECIFICATIONS
Applicable driver bit Hex. 6.35mm
Screwing capacity 5mm
Maximum torque 3.5 N
.
m
Voltage DC 3.7 V
Battery type Li-ion ( 1 cell ) 1,500mAh
Charging time Approx. 5hours
No Load speed 180 min -1
Overall length 150 mm
Net weight 0.35 kg
STANDARD ACCESSORIES
Driver bit (16pcs.), Charger, Charging stand
APPLICATIONS
(Use only for the purposes listed below.)
The machine is intended to drive in and loosen screws.
CHARGING BATTERIES (Fig.1,2)
The charger may become slightly warm while charging, but this does not affect its
performance.
When using the charging stand (Fig.1)
1. Insert the plug (13) of the charger (11) into the jack (12) of the charging stand (10).
2. Connect the charger with the outlet.
3. Firmly insert the tool into the charging stand.
During the charging, the orange LED of charger light (4) is lit. when the charging
is complete, the green LED of charger light is lit.
Note: Make sure the contact of the terminals (14)(15) and the lightening of the
LED of charger light.
4. When the charging is complete, remove the charger from the outlet.
When not using the charging stand (Fig.2)
The tool can be charged by connecting the charger directly.
Note:
1. It is normal for the handle of the tool to warm up slightly during the charging.
2. Disconnect the charger from the outlet when not in use it.
3. The battery is protected against deep discharging. When the battery is empty, a
protective circuit automatically switches off the tool.
Charge the battery when the tool is not run.
4. Length of service from each charging will depend on the type of work you are
doing.