Kyocera Mita Ecosys FS-3800, Operation Manual

Page: 52 / 306

Using the Operator Panel
1-40
Changing the Interface Parameters
The printer is equipped with both a parallel and serial interface. Option
network interface card can also be installed. Various printing environment
parameters such as the default emulation can be changed indepently on
different interfaces by using the printer's menu selection system. Before
select the interface to apply the changes in the procedure described below.
This interface selection described below does not select which interface
data will be received from. The printer automatically selects an interface
data is received.
Changing Parallel Interface Modes
The parallel interface mode of this printer supports a bi-directional/high-
speed mode. Normally, this interface is used under the default setting
AUTO
. For details, see
Appendix C
. After setting the interface, be sure to
reset the printer or turn the power off at least once. The new setting will be
enabled thereafter.
1
Press the
MENU
key.
2
Press the or key repeatedly until
Interface >
appears. One
of the interface names shown below appears, indicating the current
interface.
Parallel
(default)
Serial
Option
(when a network interface card is installed)
3
Press the
ENTER
key. A blinking question mark (
?
) appears.
If
Parallel
is not displayed, press the or key repeatedly until
it is
Parallel
.
If you want to abandon the interface selection procedure, press the
CANCEL
key. The interface remains unchanged.
4
Press the
ENTER
key again.
Interface >
Parallel
Note
MENU
ENTER Interface
? Parallel
ENTER