KYMCO People GT 300i, Service Manual

Page: 6 / 223

1. GENERAL INFORMATION
1-3
People GT 300i
SERVICE PRECAUTIONS
„
Make sure to install new gaskets, O-rings,
circlips, cotter pins, etc. when
reassembling.
„
When tightening bolts or nuts, begin with
larger-diameter to smaller ones at several
times, and tighten to the specified torque
diagonally.
„
Use genuine parts and lubricants.
„
When servicing the motorcycle, be sure to
use special tools for removal and
installation.
„
After disassembly, clean removed parts.
Lubricate sliding surfaces with engine oil
before reassembly.
„
Apply or add designated greases and
lubricants to the specified lubrication points.
„
When two persons work together, pay
attention to the mutual working safety.
„
Disconnect the battery negative (-) terminal
before operation.
„
When using a spanner or other tools, make
sure not to damage the motorcycle surface.
„
After operation, check all connecting points,
fasteners, and lines for proper connection
and installation.
„
When connecting the battery, the positive
(+) terminal must be connected first.
„
After connection, apply grease to the
battery terminals.
„
Terminal caps shall be installed securely.
„
If the fuse is burned out, find the cause and
repair it. Replace it with a new one
according to the specified capacity.