Interface Module Installation
11
down. Then push the module into the slot along the guide rail slot until it is in
position.
Figure 5 Inserting a 0.5U Interface Module into a Lower Slot
Caution:
To insert an interface module into a lower slot, keep the "TOP" identifier on the module facing
down.
If the module cannot be pushed into place, do not force it, because too much force may cause
damage to the module. In this case, remove the module and check the guide rail slot for any
foreign materials or deformation. If the fault cannot be rectified, contact our sales or technical
support personnel.
Step 2: Push the mounting brackets into the slot completely. Insert two captive screws
(M2.5×6) into the screw holes of the switch to secure the interface module to the
switch.
