KWM Gutterman PANTHER, Operating And Maintenance

Page: 36 / 37

TROUBLE SHOOTING (CONT)
After any adjustments, run gutter past adjustment area, cut that section off. Then run
a 10 foot section of gutter for inspection. Visually check gutter if needed, repeat
adjustment to completely correct problem.
Top lip curves in and bottom curves uphill.
Relieve pressure from the blue station. This is achieved by loosening bolt E 2 plcs,
Turn bolt F counter clockwise 1/2 turn. Jog gutter foreword 6", (YOU WILL SEE
COMPLETE ASSEMBLY MOVE AWAY FROM GUTTER) tighten bolt E 2 plcs.
(see pg. 21)
Top lip curves away and bottom curves downhill.
Add pressure to the blue station. This is achieved by loosening bolt E 2 plcs. Turn bolt
F clockwise 1/2 turn. Jog the gutter foreword 6", tighten bolt E 2 plcs. (see pg. 21)
Face of gutter where it meets bottom is running uphill, but the top lip is straight.
Raise the exit end of the forming box, GREEN station. This is achieved by turning bolt
J counter clockwise 1/2 turn. Turn bolt H clockwise 1/2 turn or until tight 2 plcs. (see
pg. 21)
Face of gutter where it meets bottom is running downhill, but the top lip is
straight.
Lower exit end of forming box, GREEN station. This is achieved by turning bolt H
counter clockwise 1/2 turn 2 plcs. Turn bolt J clockwise 1/2 turn or until tight.
(see pg. 21)
Back of gutter is running uphill.
Relieve pressure from bead/crimper assembly. This is achieved by loosening lock nut
on set screw Y. Turn set screw Y counter clockwise 1 full turn, tighten locking nut on
set screw Y.
(see pg. 26)
– 34 –