©2020 Spectrum Brands, Inc.
Mastercode
Programming timeout: If no button is pressed for five seconds, the system will time out
(indicated by three beeps and a red flashing lock button), and you will need to restart the procedure.
1. Make sure the audio setting on the lock is turned on / not muted.
2. Keep door open. Press and HOLD the Program button until the lock
button flashes green (about 5 seconds).
3. Enter new Mastercode.
4. Press Lock button once.
5. Re-enter Mastercode.
6. Press Lock button once.
If programming is successful, the lock button will flash green once
with one long beep.
If programming is unsuccessful, the lock button will flash red three
times with three beeps. Make sure the Mastercode has not already been
programmed. Attempt the procedure again, making sure to enter the
same new Mastercode in step 2 and 4.
7. Press the Program button once. If you hear three beeps and see the
lock button flash green, the Mastercode is enabled. Note: The lock will
time out after five seconds.
Using a Mastercode is an optional, added-security measure. It is not enabled by default. A Mastercode is
used to add and delete user codes, but it cannot unlock the door (unless the same code is programmed
as a user code, though this is not recommended). The Mastercode must be 4-8 digits.
61899 Rev 01
2 / 18
Technical Support
1-866-863-6584
www.kwikset.com
1
A
B
About the Mastercode
Enabling and Setting the Mastercode
