KW automotive TRACKTIME RaceRig, Assembly Instructions Manual

Page: 15 / 44

15
Assembly step 2
Fig.: 2 on page 28
¾
Push together both frame parts.
¾
Position the 4 stiffening plates on the underside and top of the frame so that
the fastening holes are aligned with those of the frame.
Assembly step 3
Fig.: 3 on page 29 and Fig.: 4 on page 29
¾
Screw together the crossbars (2 short, 1 long version), as well as the pedal
pad and the support bar of the pedals. To do so, push the spacer sleeves
onto the M6 screws.
¾
Screw the fastening screws with spacer sleeve through the frame and into
the components and tighten slightly by hand.
An assembly clearance must exist between the frame sides so that the next
assemblies can be mounted.
Assembly step 4
Fig.: 5 on page 30
¾
Align the holes of the pedal pad with those of the pedal support bar and
screw together with two M6×16 flanged button head screws.
Optional tuning plate
Fig.: 6 on page 30 and Fig.: 7 on page 31
¾
Alternative tuning pedal plate:
Use two M6×16 screws to fasten the front tuning pedal plate.
¾
Use both plastic spacers to level out the gap between the frame and the
plate. The flat part is mounted in the direction of the pedal plate, the part
with the radius in the direction of the frame.
Assembly step 5
Fig.: 8 on page 31 and Fig.: 9 on page 32
¾
Fasten the monitor tower on the frame using four M6×16 hexagon screws.
Lightly tighten the hexagon screws by hand.
Assembly step 6
Fig.: 10 on page 32
¾
Push one spacer sleeve onto each of the cap screws M6 × 45.
¾
Push the cap screws with spacer sleeves through the frame and steering
wheel bracket.
¾
Twist the serrated flange nut M6 onto the cap screws and tighten.