KW automotive TRACKTIME RaceRig, Assembly Instructions Manual

Page: 16 / 44

16
Assembly step 7
Fig.: 11 on page 33
¾
Push one spacer sleeve onto each of the cap screws M6 × 45.
¾
An assembly clearance is required between the frame parts so that the strut
(crossbar) can be swung in between the frame parts. To this end, undo the
fastening screws on one frame side only and then retighten after installing
the struts:
• Fastening screw Item No. 8
• Fastening screw Item No. 9
• Fastening screw Item No. 3
•
Fastening screw Item No. 5
Assembly step 8
Fig.: 12 on page 33 and Fig.: 13 on page 34
The steering wheel bracket is mounted with four M6×12 button head screws.
The optionally available direct drive bracket is installed in the same way as the
standard steering wheel bracket.
Assembly step 9
Fig.: 14 on page 34
¾
Fasten the monitor base on the frame using four M8×30 hexagon screws.
Assembly step 10
Fig.: 15 on page 35 and Fig.: 16 on page 35
¾
Turn the rig to the side by 90 °
¾
Screw one nut onto each adjustable foot.
¾
Screw the preassembled adjustable feet into the rig.
¾
Turn the rig through 90 ° and place on the adjustable feet.
¾
Use the adjustable feet to align the rig. Secure the adjustable feet with the
lock nuts.
Assembly step 11
Fig.: 17 on page 36 and Fig.: 18 on page 36
¾
Mount the monitor bracket at the required height using two M6 × 25 flanged
button head screws.
¾
Use two M6 x 12 countersunk screws to mount the monitor support at the
required height on the monitor bracket.