KW automotive TRACKTIME RaceRig, Assembly Instructions Manual

Page: 19 / 44

19
Assembly step 5 Accessories
Mounting the profile
Fig.: 28 on page 41
¾
Push two slot nuts on the right and two slot nuts on the left
Fig.: 28 Item No. 1 into the guides on the underside of the profile or swing
into the required position.
¾
Position the slot nuts in the correct position above the crossbar and exten -
sion arm.
¾
Place the profile Fig.: 28 Item No. 3 on the crossbar and profile.
¾
Screw in and tighten fastening screws Fig.: 28 Item No. 2 from below. Clamp
mounting.
NOTE
Note
The clamp is intended for fixing the keyboard bracket # 75105456. Keep in a
safe place, even if you do not use the component.
Assembly step 6 Accessories
Fig.: 29 on page 42
¾
Push two slot nuts Fig.: 29 Item No. 2 into the front groove of the profile or
swing into the required position.
¾
Position the clamp Fig.: 29 Item No. 3 in the correct position on the slot nuts
and screw in and tighten button head screw M8 x 12 Fig.: 29 Item No. 4 .
¾
In the two guides at the top of the profile, push one slot nut each
Fig.: 29 Item No. 2 into the front and rear groove or swing into the required
position.
¾
Push the caps Fig.: 29 Item No. 1 onto both ends of the profile.
Assembly step 7 Accessories
Mounting the Shifter-Bracket
Fig.: 30 on page 42
¾
Position the Shifter-Bracket Fig.: 30 Item No. 3 in the required position on
the profile. Position the slot nuts within the profile accordingly.
¾
Screw in and tighten fastening screws Fig.: 30 Item No. 1 and
Fig.: 30 Item No. 2 in the slot nuts.
¾
The Shifter-Bracket can be adjusted depending on the required height.
To do so, loosen the clamping screws Fig.: 30 Item No. 4 and set to the
required height.
¾
Re-tighten the clamping screws.