KVH Industries TracVision RV1, Installation Manual, Page: 36 / 38

35
i. Add the new receivers to the Autoswitch
page of the web interface. Enter each
receiver’s static IP address and assign it a
friendly name (e.g., “Master Bedroom”) (see
Figure 56).
Figure 56: Adding a DIRECTV Receiver to the Autoswitch Page
Also be sure to set each receiver’s Dish Type
to 3-LNB and Switch Type to SWM , and
enable external device access, as directed by
the TV-Hub’s Setup Wizard. If the TV-Hub is
then unable to communicate with the
receiver, try resetting the receiver (press its
red reset button or unplug it, wait 15 seconds,
then plug it back in and turn it on).
IMPORTANT!
Continued
Using a DIRECTV Coax Network
B