9
Follow these steps to install the TV-Hub inside
the vehicle:
a.
Tape the mounting template in the location
selected for the TV-Hub. Punch holes at each
of the two keyhole locations and at the
mounting tab location.
b.
Remove the template.
c.
Drill a 1/8" (3 mm) hole at the three hole
locations you marked in Step
a
.
d.
Install a #8 Phillips thread-forming screw
partway into one of the keyhole holes leaving
a small gap for hooking the TV-Hub onto it.
Use the thickness (2.5 mm) of the M10 washer
(supplied in the kit) as a gauge for the size
gap to leave.
e.
Repeat step
d
for the other keyhole.
f.
Peel off the backing on the adhesive-backed
washer (supplied in the kit) and place it over
the mounting tab hole (see Figure 12).
g.
Align the wide part of the TV-Hub’s
keyholes, as shown in Figure 13, over the
screws, then slide downwards to secure the
screws into the narrow part of the keyholes.
h.
Press the rear mounting tab on the TV-Hub
onto the adhesive washer and install the third
#8 Phillips thread-forming screw in the
mounting tab hole.
7.93"
(20.1 cm)
3.17"
(8.1 cm)
4.86"
(12.3 cm)
Front of TV-Hub
Keyhole
2 x Ø 0.13"
(Ø 0.3 cm)
Mounting Tab
Ø 0.13"
(Ø 0.3 cm)
Figure 12: TV-Hub Mounting Template
Keyhole (x2)
Mounting Tab
Figure 13: TV-Hub Keyholes and Mounting Tab
Mount the TV-Hub
7
Summary of Contents for TracVision RV1
Page 1: ...KVH Industries Inc Installation Guide TracVision RV1...
Page 37: ......
