Kval 990-H, Service Manual

Page: 64 / 104

Replacing Bits
3-25
KVAL 990-H Service Manual
Replacing Bits
Replacing Tooling in the Front Section
This machine is a powerful electro-mechanical
motion control system. If servicing this machine fol-
low all safety guidelines Failure to do so can result in
damage to equipment and/or serious injury to person-
nel.
Caution
Replacing Bits in the Front Section
This section describes the steps to change the pre-drill bits, router bits, and chisels in the heads on
the front section., shows the locations of the replaceable parts inside the heads
Drill Motor
Chisels:
Upper and
Lower
Right
Router Motor
Chisels:
Upper and
Lower Left
FIGURE 3- 14.
Location of Bits in the 990-H Heads